[MT-ALES] Radian Flaps

[Montana ALES reflector]

Please disregard the 1x12 that I sent earlier.  I just measured my 
Radian wing and you can indeed go out to 18 or 19" per side before you 
start getting into the upswept portion.

--
Greg



On 1/27/2019 2:54 PM, Montana ALES reflector wrote:
> 19x1.5 inches works fine, I have that setup on mine that Jim L and I did.
>
> Best,
>
> Jon
>
> Powered by Soaring
>
> On Jan 27, 2019, at 14:34, Montana ALES reflector 
> <mt-ales at lists.webworks.net <mailto:mt-ales at lists.webworks.net>> wrote:
>
>> I just read on rcgroups that the standard seems to be 1x12 inches.  
>> Any longer than that and it starts getting into that upward sweeping 
>> elliptical polyhedral.  You don't want to be hinging that.  The guy 
>> also said he uses Blenderm tape hinge, bottom only, and a regular 
>> (cheap) 9G servo.
>>
>> --
>> Greg in Kalispell.
>>
>>
>> On 1/27/2019 2:21 PM, Montana ALES reflector wrote:
>>>
>>> I was asked this question and I don't know the answer….
>>>
>>> Question that is the general length of the flaps that the guys up 
>>> there like using on their Radians ?
>>>
>>> Thanks
>>>
>>> Curtis
>>>
>>>
>>> _______________________________________________
>>> MT-ALES mailing list
>>> MT-ALES at lists.webworks.net
>>> http://lists.webworks.net/cgi-bin/mailman/listinfo/mt-ales
>>
>> _______________________________________________
>> MT-ALES mailing list
>> MT-ALES at lists.webworks.net <mailto:MT-ALES at lists.webworks.net>
>> http://lists.webworks.net/cgi-bin/mailman/listinfo/mt-ales
>
> _______________________________________________
> MT-ALES mailing list
> MT-ALES at lists.webworks.net
> http://lists.webworks.net/cgi-bin/mailman/listinfo/mt-ales

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.webworks.net/pipermail/mt-ales/attachments/20190127/aa5795b5/attachment-0001.html>